The Brodit Vehicle Headrest Mount for iPad is ideal for your children or passengers to watch movies or slideshows in the car. Installed onto the front seat's headrest. It comes with a tilt swivel so the iPad can be adjusted in order to avoid reflection. It's easy to take the iPad with you when leaving the vehicle. The installation is quick and will not damage the interior of the vehicle.

The headrest iPad mount is designed to fit most vehicles. Please measure the distance between the vehicles head rest bars to confirm the compatibility:

- Minimum inner size between the head rest bars: 95 mm
- Maximum outer size between the head rest bars: 211 mm.



Installation Guide
Please read all of the instructions and look at the pictures before attaching the headrest mount.

1. Remove the two screws in the frontside of the headrest mount using the enclosed tool, so you get two parts. Loosen the screw underneath the headrest mount so the face plate can be slided in the groove. Place the headrest mount under the headrest and adjust the face plate. Tighten the screw underneath so the face plate is locked into desired position. Place one part of the headrest mount on each side of the headrest. The face plate is to be on the back side of the headrest. Put back the screws. Tighten the screws on the frontside of the headrest mount. Screw until the headrest mount is properly in place. Attach the monitor mounting plate onto the headrest mount. Tighten the screw in the face plate.

2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder.

3. To remove the device from the holder: Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.